New Parkerizing / Matching Numbers / New U.S. Barrel
AMD 65 "Folding Stock" Rear Trunnion - What A Find.
Barrels are pressed and assembled onto receivers and fully headspaced as a completely finished barreled action and upper assembly.
Comes exactly as pictured, considered a finished rifle due to degree of completion... FFL required for purchase.
Note - Pistol Grips vary from kit to kit and may be either polymer or wood depending on availability.
Kit includes:
Original FEG receiver “heavy wall” with 10 round mag-well opening, single stack (see photos)
(We do not have 10 rd in line mags available).
Receiver has AMD 65 Rear Trunnion. If original side folding stock will be used receiver must be cut in side and holes drilled in bottom for butt release screw and pivot pin.
New 16.5” U.S. Barrel (non-chrome), pressed into the front trunnion and headspaced. Checked with Go/No-Go Gauges and live round. (headspace must be checked by a competent gunsmith after final assembly).
Matching Part #’s on all major components, receiver cover and gas tube #’s match if numbered
Rear Sight, Gas Block, and Front Sight installed in proper alignment and parkerized.
AMD 65 Folding Butt Stock with hardware
Bolt & Bolt Carrier
New Parkerizing on all parts
All parts are original AMD 65 with the exception of the new U.S. barrel
Does not include a magazine.
Photo shows all parts included and is representative of the kits offered.
These were originally slated to be built in Hungary and imported in low cap form to be 922r'd here state side and sold as high cap rifles. Well, the deal to bring them in fully assembled fell through when FEG disbanded. They were ultimately imported as parts sets.... including the low cap receivers... All parts have been professionally parkerized and the barreled actions have been completed onto the low cap receivers. They are ready to be final assembled as Low cap rifles, or add a few U.S. parts and open the mag well for a fully compliant Hi Cap rifle. Once the receivers are high capped they will accept all high cap mags and drums.
These are very nice.
Hey Guys - All of the heavy lifting has already been done on these. They are ready to be final assembled as is, or, they can be 922r'd and the mag wells opened up to allow for a high cap rifle build. The barrel is already U.S. made, drop in a Tapco 3 piece trigger set, and a U.S. made mag, and you have more than enough parts to legally do the final build on this as a high cap rifle. Perfect as a home work shop build project.